PCHR/L-24 :  PENTACUT holders for 5 cutting edged inserts, used for grooving, parting and recessing.  
 Right-hand shown
 
Parting   Ext. Grooving  
  Designation
h
b		 W
min		 W
maxThe Wmax value for standard PENTA 24 inserts is 3.18
f
l1
l2
h4
R/L
Tmax-rFor specific information, refer to insert data.
  PCHL 10-24  10.0  10.0  0.50  3.20Up to 6.2 mm width may be ordered on request  8.5  120.00  19.5  6.0  L  6.50
  PCHR 10-24  10.0  10.0  0.50  3.20Up to 6.2 mm width may be ordered on request  8.5  120.00  19.5  6.0  R  6.50
  PCHL 12-24  12.0  12.0  0.50  3.20Up to 6.2 mm width may be ordered on request  10.5  120.00  19.5  4.0  L  6.50
  PCHR 12-24  12.0  12.0  0.50  3.20Up to 6.2 mm width may be ordered on request  10.5  120.00  19.5  4.0  R  6.50
  PCHL 16-24  16.0  16.0  0.50  3.20Up to 6.2 mm width may be ordered on request  14.5  120.00  19.5  -  L  6.50
  PCHR 16-24  16.0  16.0  0.50  3.20Up to 6.2 mm width may be ordered on request  14.5  120.00  19.5  -  R  6.50
  PCHL 20-24  20.0  20.0  0.50  3.20Up to 6.2 mm width may be ordered on request  18.5  120.00  19.5  -  L  6.50
  PCHR 20-24  20.0  20.0  0.50  3.20Up to 6.2 mm width may be ordered on request  18.5  120.00  19.5  -  R  6.50
  PCHL 25-24  25.0  25.0  0.50  3.20Up to 6.2 mm width may be ordered on request  23.5  135.00  19.5  -  L  6.50
  PCHR 25-24  25.0  25.0  0.50  3.20Up to 6.2 mm width may be ordered on request  23.5  135.00  19.5  -  R  6.50
  PCHL 25-24-8  25.0  25.0  6.25  8.20  22.5  135.00  19.5  -  L  6.50
  PCHR 25-24-8  25.0  25.0  6.25  8.20  22.5  135.00  19.5  -  R  6.50

Print  Send by mail  Save to word  Save to Excel