GHIUR/L-C-A(15° & 27.5°)Bars :  Internal grooving and turning bars for machining aluminum wheels.  
 Right-hand shown
 
Int. Machining Aluminum Wheels   COOLANT 
  Designation
W
d		 D
min
Tmax-rDimension for minimum bore diameter.
l1
l2
f
F1
h1
a°
Coolant
  GHIUL 40C-15A-6  6.00  40.00  160.00  -  320.00  83.0  21.2  19.0  18.0  15.0  Y
  GHIUR 40C-15A-6  6.00  40.00  160.00  -  320.00  83.0  21.2  19.0  18.0  15.0  Y
  GHIUL 40C-15A-8  8.00  40.00  160.00  0.00For bore diameter D>200, Tmax is 0.5 mm  320.00  83.0  21.0  18.0  18.0  15.0  Y
  GHIUR 40C-15A-8  8.00  40.00  160.00  0.00For bore diameter D>200, Tmax is 0.5 mm  320.00  83.0  21.0  18.0  18.0  15.0  Y
  GHIUL 50C-15A-8  8.00  50.00  100.00  0.00For bore diameter D>200, Tmax is 1.4 mm  350.00  83.0  26.0  23.0  23.0  15.0  Y
  GHIUR 50C-15A-8  8.00  50.00  100.00  0.00For bore diameter D>200, Tmax is 1.4 mm  350.00  83.0  26.0  23.0  23.0  15.0  Y
  GHIUL 40C-27.5A-6  6.00  40.00  90.00  0.60For bore diameter D>200, Tmax is 4.0 mm  320.00  80.0  25.1  23.5  18.0  27.5  Y
  GHIUR 40C-27.5A-6  6.00  40.00  90.00  0.60For bore diameter D>200, Tmax is 4.0 mm  320.00  80.0  25.1  23.5  18.0  27.5  Y
  GHIUL 40C-27.5A-8  8.00  40.00  108.00  1.60For bore diameter D>200, Tmax is 4.0 mm  320.00  81.0  25.2  23.0  18.0  27.5  Y
  GHIUR 40C-27.5A-8  8.00  40.00  108.00  1.60For bore diameter D>200, Tmax is 4.0 mm  320.00  81.0  25.2  23.0  18.0  27.5  Y
  GHIUL 50C-27.5A-8  8.00  50.00  120.00  1.80For bore diameter D>200, Tmax is 4.0 mm  350.00  82.0  30.2  28.0  23.0  27.5  Y
  GHIUR 50C-27.5A-8  8.00  50.00  120.00  1.80For bore diameter D>200, Tmax is 4.0 mm  350.00  82.0  30.2  28.0  23.0  27.5  Y

Upper jaw with hard coating to sustain chip deflection
Print  Send by mail  Save to word  Save to Excel


Terms of Use and Legal Disclaimer