GEHIMR/L-SC :  Internal machining carbide bars with a coolant holes. Using GEMI and GEPI inserts in widths smaller than 1.9 mm (the insert is not fully supported).  
 Right-hand shown
 
Int. Grooving   Int. grooving (side limit)   Int. Groov & Turn   Int. Profiling   Threading (Int.)   COOLANT 
  Designation W
min		 W
maxPocket can carry inserts up to 3 mm width.
d		 D
min
Tmax-r
l1
l2
f
h1
Inlet
  GEHIML 10SC-13  0.80  1.90  10.00  12.50  2.50  125.00  30.0  7.6  5.0  3.5 mm
  GEHIMR 10SC-13  0.80  1.90  10.00  12.50  2.50  125.00  30.0  7.6  5.0  3.5 mm
  GEHIML 12SC-14  0.80  1.90  12.00  14.00  2.50  125.00  40.0  9.0  6.0  6.0 mm
  GEHIMR 12SC-14  0.80  1.90  12.00  14.00  2.50  125.00  40.0  9.0  6.0  6.0 mm
  GEHIML 16SC-13  0.80  1.90  16.00  12.50  2.50  125.00  35.0  10.6  7.5  M6Plastic seal with M6 thread.
  GEHIMR 16SC-13  0.80  1.90  16.00  12.50  2.50  125.00  35.0  10.6  7.5  M6Plastic seal with M6 thread.
  GEHIML 16SC-14  0.80  1.90  16.00  14.00  2.50  140.00  40.0  10.9  7.5  M6Plastic seal with M6 thread.
  GEHIMR 16SC-14  0.80  1.90  16.00  14.00  2.50  140.00  40.0  10.9  7.5  M6Plastic seal with M6 thread.
  GEHIML 16SC-16  0.80  1.90  16.00  16.00  2.50  160.00  70.0  10.5  7.5  M6Plastic seal with M6 thread.
  GEHIMR 16SC-16  0.80  1.90  16.00  16.00  2.50  160.00  70.0  10.5  7.5  M6Plastic seal with M6 thread.

Print  Send by mail  Save to word  Save to Excel


Terms of Use and Legal Disclaimer