New Solid Carbide
7 Flute CHATTERFREE Endmills with Chip-Splitting Cutting Edge
Highlights
ISCAR is expanding the SOLIDMILL line of 7 flute CHATTERFREE solid carbide endmills by adding tools with chip-splitting cutting edges.
The new ECP-H7-CF family features 3xD, 4xD and 6xD cutting length to diameter ratios for 6 to
16 mm diameter tools and 3xD and 4xD for 20 mm diameter tools.
The new chip-splitting solid carbide endmills are intended for rough to semi finish machining at
high cutting speed and can also be applied to high speed milling (HSM) operations. ECP-H7-CF
endmills provide an improved performance and higher versatility than the tools available up till now,
which possess cutting edges without chip-splitting grooves, particularly at high overhang.
Designation key code
Nominal tool diameter
Cutting length
Shank diameter
O.A.L
Features
7 flute different helix and variable pitch solid carbide endmills with chip-splitting geometry
for rough to semi-finish operations as well as HSM by trochoidal method
Unique design of chip-splitting grooves on the cutting edge provides satisfactory
surface finish for most requirements
Enlarged chip flute for effective chip evacuation
Produced from IC902, an ultra-fine carbide grade with TiAlN PVD coating providing excellent
performance in machining various materials, especially, hard steel and cast iron.
h6 shank tolerance
Advantages
Very high productivity on most material types
Excellent chip evacuation
Low cutting forces
Designed mainly for rough to semi-finish operations, it also provides a satisfactory surface finish even at maximum ap
High performance in a wide range of machining speeds
Optimal flute design delivering maximum metal removal rates
ECP-H7 after 10 min milling alloy steel SAE4340
EC-H7 after 10 min milling
Application Instructions
Endmill that is longer than necessary is less rigid and requires reducing the cutting conditions.
The new cutting length options with chip-splitting provide an optimal tool for very high-speed machining and enable machining even under less favorable conditions.
Width of cut (ae) should be set depending on the cutting length:
For endmills with 3xD cutting length - up to 0.3xD max. according to system stability
For endmills with 4xD cutting length - up to 0.25xD max. according to system stability
For endmills with 6xD cutting length - up to 0.1xD max. according to system stability
Cutting data
The attached table provides estimated starting cutting data. For machining in unstable conditions, the table data should be reduced by 20-30%.
ChatterFree and Chip-Splitting -
A Winning Combination!
ECP-H7-CF
7 Flute Solid Carbide Endmills with Different Helix, Variable Pitch and Chip Splitting Cutting Edges
(1) Number of flutes (2) C-Cylindrical (3) Corner radius tolerance (+/-)
ECP-H7-CF (continued)
7 Flute Solid Carbide Endmills with Different Helix, Variable Pitch and Chip Splitting Cutting Edges
1) Number of flutes (2) C-Cylindrical (3) Corner radius tolerance (+/-)