Page 19 - ISCAR FACE GROOVING LINES

PICCO-620 OAL IC1008
(Groove Along Shaft)
Inserts for Grooving Along CDX DCONMS FACE GROOVE-TURN
a Shaft Dmin 6 mm OHN DAXN

a Right-hand shown
CW
Recommended
METRIC Machining Data
Dimensions
f face-groove
Designation DAXN(1) CW CDX DCONMS a OHN(2) OAL (mm/rev)

PICCO R 620.1006-20 6.0 1.00 2.00 6.00 5.20 20.0 35.00 • 0.01-0.04
6.00 5.20 20.0 35.00 • 0.01-0.05
PICCO R 620.1506-20 6.0 1.50 3.00 6.00 5.20 20.0 35.00 • 0.02-0.06
6.00 5.20 20.0 35.00 • 0.02-0.06
PICCO R 620.2006-20 6.0 2.00 4.00 6.00 5.20 20.0 35.00 • 0.02-0.06

PICCO R 620.2506-20 6.0 2.50 5.00

PICCO R 620.3006-20 6.0 3.00 6.00

• Only right-hand inserts are available as standard, left-hand inserts on request • All carbide inserts are with sharp corners
• For detailed cutting data, see pages 162-164
(1) Minimum axial grooving diameter
(2) Minimum overhang

PICCO-620 OAL
(Groove Along Shaft)
Inserts for Grooving Along CDX DCONMS
a Shaft Dmin .236" OHN DAXN

a Right-hand shown
CW
Recommended
INCH Machining Data
Dimensions
f face-groove
Designation DAXN(1) CW CDX DCONMS a OHN(2) OAL IC1008 (IPR)

PICCO R 620.1006-20 .24 .039 .079 .236 .205 .787 1.378 • .0004-.0016
PICCO R 620.1506-20 .24 .059 .118 .236 .205 .787 1.378 • .0004-.0020
.24 .079 .157 .236 .205 .787 1.378 • .0008-.0024
PICCO R 620.2006-20 .24 .098 .197 .236 .205 .787 1.378 • .0008-.0024
.24 .118 .236 .236 .205 .787 1.378 • .0008-.0024
PICCO R 620.2506-20
PICCO R 620.3006-20

• Only right-hand inserts are available as standard, left-hand inserts on request • All carbide inserts are with sharp corners
• For detailed cutting data, see pages 162-164
(1) Minimum axial grooving diameter
(2) Minimum overhang

17